EDM Product 07681 Manual De Instrucciones página 20

Instrucciones importantes de seguridad / instruções importantes de segurança
Ref. 07681
Important safety instructions
STEAM IRONING
- Place the iron in a vertical position and set the temperature control dial at the
minimum/low heat setting.
- Insert the plug into the socket, and then turn the temperature control dial to the "high
heat" marking. The pilot light will come on, indicating that the iron is heating up.
- When the pilot light turns off, the set temperature has been reached and the iron is
ready to use.
- During ironing,the pilot light on the iron automatically switches on/off as the
thermostat maintains the set temperature(you may continue ironing during this
process).
- Turn the steam control turning knob to the required position.
- Steam is produced as soon as the iron in held horizontally.
SPRAYING
- Press the spray button to spray water on clothes, as often as required.
Note: When using the water spray function, ensure that there is enough water in the
water tank, and you may have to pump the spray button serval times at first time you
use the iron in order to start the spraying function.
BURST OR VERTICAL STEAM IRONING
- Press the burst of Steam button to generate a powerful burst of steam that can
penetrate the fabrics and smooth the most difficult and tough creases. Wait for a few
seconds before pressing again.
- By pressing the Burst of Steam Button at intervals you can also iron vertically
(curtain,hung garments, etc.)
Note: The burst steam function can only be used at high temperature. Stop the emission
when the pilot light turns on, then start ironing again only after the pilot light has turned
off.
-5-