Publicidad
Idiomas disponibles
Idiomas disponibles
highchair assembly
1 – assembling the seat
Fit the seat unit
(1)
to the seat frame (2). Push down on the seat unit until it locks in place at
(A)
& (B).
2 – fitting the legs
2A
Turn the seat assembly over and fit the four upper legs
(3)
into the mountings on the base of the
seat frame. Adjust the position of the legs until the spring loaded pins locate in the holes in the
mountings (A).
2B
Push the rear upper legs together a little
(B)
and fit the rear support bar (8). Push the front upper
legs together a little
(C)
and fit the footrest (9).
– fitting the legs (continued)
3
Noting the identification marking on the underside of seat unit, align the holes in the rear support bar,
footrest and upper legs (D). Fit the lower legs
(4 -
(5 -
(6 - RR)
&
(7 - RL)
into the bottom of the
FR),
FL),
rear support bar and footrest until the spring loaded pins locate in the holes. There are identification
markings on each lower leg and the seat assembly to show where each lower legs should be fitted.
When all the legs are fitted turn the assembly the right way up.
4 – fitting the tray
Place the tips of the tray
(11)
into the seat unit at
(A)
Position the latch underneath the tray so it is
aligned with the slot in the front of the seat unit. Press the tray down at
(B)
until it locks in place.
Check the security of the tray before use.
To remove the tray, reverse the above instruction.
Note: Only slide the tray horizontally when fitting or removing tray. Damage could occur if the tray is
fitted or removed at an acute angle.
5 – fitting the harness
Flatten the butterflies
(A)
on the harness (10). Push the butterflies through the slots in the seat then
o
turn the butterflies through 90
(B).
6 – using the harness
To release the harness push in the tabs at (A).
To fasten the harness push the tabs on the waist straps into the buckle (B).
To adjust the harness slide the straps through the adjusters to the required lengths.
(X, Y &
Z).
Publicidad
