AENO VS1 Manual Del Usuario página 9

the both sides. After a distinctive click both cover latches (12) will lock
automatically.
4. Press the "Seal" button (5) on the device twice. The blue light (6) on the
control panel will light up which means that the sealing process has started.
5. When sealing is complete the device will turn off automatically and the
indicator light on the control panel will turn off.
6. Turn the "Releasing Valve" (2) to release air. Press the two cover release
buttons (1) located on each side of the housing simultaneously. The lid will open
automatically.
7. Remove the bag.
Vacuuming and sealing bags
The process is the same as described above under "Sealing packages" only
instead of pressing the "Seal" button (5) you must press the "Vac Seal"
button (4) twice.
At the end turn the "Releasing Valve" (2) to release air.
Vacuum packing in containers and bags with a valve
Note. Vacuuming containers and valve bags are not included.
1. Place the food in the special vacuum container (bag with valve) and close
the lid of the container (ZIP-LOCK of the bag).
2. Connect the outlet valve (13) of the container (bag) and the "Air Suction"
port (3) on the vacuum sealer with the adapter (vacuum hose) (8) (see Fig. c).
3. Make sure the container (bag) is tightly closed.
4. Close the lid of the vacuum sealer and press it lightly against the housing on
the both sides. After a distinctive click both cover latches (12) will lock
automatically.
5. Connect the device to a power source by inserting the plug of the power
cord into a power outlet.
aeno.com/documents 9