Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
NOTE: When the battery charge is low, the speaker will say
"Battery Low".
DISCONNECTING BLUETOOTH
Press and hold the BLUETOOTH
to disconnect a paired BLUETOOTH
ADJUSTING THE VOLUME:
To increase the volume, press the + button.
To decrease the volume, press the – button.
NOTE: Volume for any connected device can be adjusted
using the volume control for that device and/or with the +
or – buttons on the product.
PAUSE AND PLAY:
Briefly press and release the BLUETOOTH
cycle between pausing and playing the audio.
USING A BLUETOOTH
(NOT INCLUDED) WITH THE SPEAKER
See Figure 3, page 9.
Install a battery pack and turn the speaker on.
NOTE: The speaker will say "Power On" and automatically
attempt to connect to the last device it was paired to. If
no device has been previously paired, the
Set your device to search/scan for available BLUETOOTH
signals, then select "RIDGID Speaker R84088" from the
list. No password or PIN is required for connection.
NOTE: For best results, BLUETOOTH
should be within 50 ft. of the speaker and set to search/
scan in order to pair with the speaker.
When the device has successfully paired with the speaker,
the speaker will say "Bluetooth Connected" and the
turn solid.
NOTE: If the speaker does not pair with your device, turn
the power to the speaker off, wait 5 seconds, then turn
the power back on and start the pairing process again.
NOTE: Maintenance information begins on page 7 after French and Spanish
This product has a 90-Day Satisfaction Guarantee Policy, as well as a
Three-year Limited Warranty. For Warranty and Policy details,
please go to powertools.ridgid.com or call (toll free) 1-866-539-1710.
®
DEVICES:
®
button for three seconds
®
device.
®
button to
ENABLED DEVICE
®
will flash.
®
enabled devices
language sections. Illustrations start on page 8.
NOTE: When a device is paired to the speaker, information
for connecting to the device is saved in the speaker's
memory.
To disconnect the BLUETOOTH
and hold the BLUETOOTH
When the device is disconnected, the speaker will say
"BLUETOOTH
speaker will search for a BLUETOOTH
NOTE: The speaker will not automatically connect to the
device it was just disconnected from.
USING THE USB DEDICATED CHARGING PORT
See Figures 4 - 5, page 9.
The USB dedicated charging port provides charging power
of 5 Volts DC at up to 2 Amp for your cell phone, MP3 player,
or other USB devices.
NOTICE:
Attempting to charge devices rated more than 2.1
Amp, such as a tablet, could damage the USB
dedicated charging port and/or the device.
Connect one end of a USB cable (not provided) to your
USB device.
®
Connect the other end of the USB cable (not provided) to
the USB dedicated charging port to begin charging the
device.
NOTE: The USB dedicated charging port provides
power only; it does not provide any data communication
capabilities.
The USB dedicated charging port will continue to function
will
as long as the speaker is on. If the speaker is off, charging
will stop.
NOTE: The speaker will turn off in 30 minutes if no audio
has been streamed. Turn the speaker on to resume
operation.
6 - English
®
enabled device, press
®
button for three seconds.
®
disconected", the
will flash, and the
®
signal.
Publicidad
