Descargar Imprimir esta página

LIVARNO home 353695 2010 Instrucciones De Montaje, De Uso Y De Seguridad página 26

Grifería para lavabo

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Remove the cap
22
screwdriver (see Fig. J).
Release the locking screw
clockwise using a hexagon socket screw key
CAUTION! Do not take the screw completely
out; just loosen it until the control lever
be easily taken off.
Take off the control lever
Loosen the cartridge end ring
screw off the cartridge locking ring
a pipe wrench.
Now pull the setting ring
help of a screwdriver.
Note: Do not remove the cartridge
Place the setting ring
as shown in Fig. K.
Note: The setting ring
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
tap body
again by using a pipe wrench,
1
then tighten the cartridge end ring
Place the control lever
body
and tighten the locking screw
1
turning it clockwise using a hexagon key
Press the cap
into the opening.
22
Turn on the main water supply and check the
temperature limiter.
Water-saving function
The cartridge
in this tap has a water saving
26
function. This feature limits the water flow through
the tap. This means you can save up to 50 %
water (see fig. L).
Lift the control lever
resistance. This resistance will cause a stop in
case of partial opening and will therefore simply
limit the flow of water.
If you want to increase the flow rate, exert slight
pressure on the control lever
come the resistance.
26 GB/MT
carefully by a small flat
by turning it anti-
21
can
20
.
20
by hand, then
23
by using
24
upwards with the
25
.
26
in the desired position
25
can limit the turning
25
onto the
24
by hand.
23
back on to the tap
20
by
21
9
until you notice a slight
20
until you over-
20
Maintenance and cleaning
Tap care and cleaning
.
9
Please note that sanitary fittings require special care
and attention. Therefore you should follow the fol-
lowing advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle
and remove lime deposits of foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.
Disposal
The packaging is made entirely of recyclable materials,
.
which you may dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Information
Potability of mains water
Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.
The following general recommendations
apply to the potability of the water from
your pipework:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant water
in the preparation of food or for drinking. This
applies particularly as far as babies and infants
at regular intervals
27

Publicidad

loading