Corsair HS65 WIRELESS Manual De Instrucciones página 4

ENGLISH
LISTENING TO MUSIC (MEDIA PLAYBACK)
To play a track, single press the MFB. To pause playback, single press the MFB again. To skip forward, press the
MFB twice quickly. To skip backwards, press the MFB three times quickly.
FOR OPTIMAL WIRELESS PERFORMANCE
• Place the wireless USB receiver in an open, unobstructed area.
• Make sure the battery is fully charged before initial use.
• Do not leave the battery fully discharged for long periods. Battery life is maximized by keeping the battery in a
partially charged state.
• Keep the headset at room temperature (20-30°C or 68-86°F).
NOTE: Prolonged listening at high volumes may adversely affect your hearing. Take breaks between sessions and
always begin with the volume at a low level before increasing.
MICROPHONE CONTROL
Flip-up microphone to mute. Flip-down microphone to unmute. Alternatively, you can use the mute button on
the headset. Holding the mute button toggles on/off sidetone.
For best performance, bend the flexible microphone boom to best fit near the left corner of your mouth.
A 30-degree bend is a good place to start, but you can adjust this if your mic is too loud or too soft.
VOLUME CONTROL
Use the volume control/EQ select wheel to adjust volume up or down. In addition, pressing the volume wheel cycles
through four audio EQ presets: Standard, Bass Boost, Movie Theater, and FPS Competition.
CHARGING
The CORSAIR HS65 WIRELESS headset must be fully charged before its first use.
> Connect the USB charging cable to any working USB port on your PC.
> Connect the USB charging cable to the CORSAIR HS65 WIRELESS Headset.
The CORSAIR HS65 WIRELESS headset battery has no "memory effect", so there is no need to completely
discharge it before recharging. Remember that the USB charging cable requires a high power (USB 2.0 or better)
port. Some USB ports found on older devices do not support USB 2.0.
BATTERY STATUS LED INDICATIONS (ON HEADSET)
LOW MEDIUM HIGH
RED ORANGE GREEN
The status LED will pulse while being charged and turn solid green at full charge. When not being charged, the
status LED will blink based on the power levels shown above.
3