BYK o-visc RT Lite Instrucciones página 8

byko-visc RT Lite
4 Measurement Settings
Tap the settings icon in the main menu to manage settings changed often.
Spindle
Speed
Density
Time to Stop
Time to Torque
Configuration
Use back navigation icon ( < ) to go back to previous page. Current settings will be saved.
NOTICE
Settings for Speed and Spindle will be used as defaults and can also be changed directly
during measurements.
8
Select spindle based on spring. Only spindles applicable to
your model will be shown.
Select a speed from the predefined list from 0.3 to 200 rpm (in
21 steps). Spindle and speed combination will show the max-
imum viscosity that can be measured with this combination.
Available if Density is activated in System Configuration.
Set measurement time in hours / minutes / seconds.
Set torque measurement at which the unit will stop when
reached.
Check and change system settings, see System Configura-
tion.
BYK-Gardner GmbH
300 003 477 - 2301