Mac Mah FOGSPRAY 3000 RGB Manual De Instrucciones página 10

HF REMOTE CONTROL :
- Button 1 = Smoke release
- Button 2 = Color selection
- Button 3 = Color fade mode
- Button 4 = Activates or deactivates the LEDs
Maintenance
The volume of smoke produced may decrease over time. It is possible that your machine
is clogged. Before using a specialized cleaning product, we recommend that you follow
the instructions below:
- If there is any smoke fluid left in the tank, it must be completely emptied. Fill the tank
with mineral/distilled water.
CAUTION: Never use tap water, as this may cause irreversible damage to the pump and
the heating element.
- Fill the tank with approximately 1 liter of demineralized water.
- Turn on the machine and let it warm up.
- When the machine is hot, set the flow rate to maximum continuously.
- You will notice that the machine will produce smoke at first, this is the remaining smoke
liquid present in the tubes and heating body. After a few minutes this smoke should turn
into a clear liquid, this is the demineralized water that starts to come out
- Let the machine run for about 15 minutes.
- Turn off the machine. Wait for it to cool down completely and then drain the excess
demineralized water.
9