Vertex Standard VAC-6030B/AAH27X001 Guia Del Usuario página 7

All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
The Charger System is a fully automated battery care system. All a
user needs to do is follow these simple steps:
1. Place the radio battery into the charger.
2. Remove the radio / battery when it's fully charged (LED turns
steady GREEN).
The charger pockets accommodate either a radio with a battery
attached or a battery alone. Prior to charging a radio with a battery,
turn the radio off. Batteries charge best at room temperature.
Charging Procedure
1. Plug the charger end of the power supply cord into the power
receptacle located at the back of the charger.
2. Plug the wall receptacle end of the power supply cord into the
appropriate AC outlet. A successful power-up sequence is
indicated by a SINGLE GREEN BLINK on the charger indicator.
3. Insert a battery, or a radio with a battery (with the radio turned
off), into the charger's pocket by:
a. Aligning the groove on each side of the battery with the
corresponding raised rail on each side of the charger pocket.
b. Pressing the battery toward the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring complete
contact between the charger and battery contacts.
4