kooa GEAR MINI Manual De Instrucciones página 19

‚ We recommend that you operate the device from a
power outlet with a residual current device (RCD) and
a tripping current of no more than 30 mA for additional
protection. Consult a quali ed electrician for advice.
‚ Only plug the charger into a properly installed power
outlet with a voltage corresponding to the "Technical
data".
‚ Ensure you can easily access the power outlet so that
you can quickly unplug the mains adaptor if necessary.
‚ Fully unwind the charging cable before charging.
Ensure the charging cable cannot be damaged by sharp
edges or hot objects.
‚ Remove the trimmer from the charging tray and unplug
the mains adaptor from the socket:
– when not in use,
– when the battery is fully charged,
– when a noticeable fault occurs during charging
(e.g. smoke, odour, etc.),
– before cleaning, maintaining or packing away the
device,
– during a thunderstorm.
When doing so, always pull on the mains adaptor, not
on the cable.
‚ Do not modify the device. The damaged unit must only
be repaired in a specialist workshop to avoid hazards.
Observe the warranty terms and conditions.
‚ Visually inspect the device before each use. If the device
is damaged, have it repaired in a specialist workshop
before using it again.
RISK of injuries
‚ Never touch the trimmer blade when the device is
switched on.
‚ You must switch o the device when
... you lay it aside to charge it or make a short break
during trimming,
... you attach or remove the comb attachment,
... you are about to lubricate or clean it.
‚ The trimmer blade may get hot a er prolonged use.
Burns risk!
19