Descargar Imprimir esta página

GreenWorks BPS40B00 Manual De Instrucciones página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

proper disposal of the solution. Pumping causes air to be
taken in, and the remaining liquid needs to be discharged.
Pump until all liquid and air are completely discharged
through the nozzle. Refill the tank with a few quarts of soapy
water (a mild dish detergent is recommended) and discharge
as previously instructed. If necessary, repeat this procedure
several times to ensure that the sprayer is clean. Sporadic
spray distribution is caused by a clogged nozzle. If necessary,
remove and clean nozzle.
Maintenance and storage
After use, the sprayer should be properly cleaned and stored
away from direct sunlight to prevent UV damage. Before
storing for the winter, be sure that all liquid is completely
drained from the tank, lines and air chamber. (Refer to the
CLEANING AND MAINTAINING THE SPRAYER
instructions above). Regularly inspect hose, pump tank for
water, damage or leaks.
10
TROUBLESHOOTING
PROBLEM
POSSIBLE
CAUSE
Liquid leaks.
Nut may be
loose or rubber
seal is cracked or
damaged.
Liquid leaks
Lid not screwed
from the lid.
on tightly or seal
is cracked or
damaged.
Tank starts to
Vent holes in
collapse; tank
tank lid have be-
lid cannot be
come clogged.
unscrewed cre-
ating vacuum.
Low or no pres-
Battery is out of
sure.
charge, switch is
in "off" position
or tip nozzle is
stuck.
Tank leaks at
Seals are dam-
pump connec-
aged.
tion.
Tank leaks at
The hose clamp
pump.
is loose.
Tank leaks at
Clamp is loose
hose connec-
or damaged.
tion.
Diaphragm is
Diaphragm is
leaking.
damaged.
English
SOLUTION
Tighten the nut and/or
replace the seal and lu-
bricate.
Tighten lid. Lubricate
the seal, replace if nec-
essary.
Remove cap and with a
small wire, unclog the
holes. Clean the cap,
check the valve. Lubri-
cate check valve and
reinstall.
Charge the battery to
full charge, turn switch
to ON position, un-
screw nozzle, and re-
move debris.
Replace damaged seals
Tighten the hose clamp.
Tighten clamp or re-
place if damaged.
Replace diaphragm.
11
PROBLEM
POSSIBLE
CAUSE
The battery is
not charged.
Battery is too
cold.
The machine
does not start.
11
TECHNICAL DATA
Rated Voltage
40V; Cordless, battery powered
Max. Pounds Per
70 PSI (0.5 MPA)
Square Inch Pressure
Rated Gallons Per Mi-
0.5 GPM (1.89 L/min)
nute
Maximum Inlet Water
104 °F (40 °C)
Temperature
Cleaning Units
35 C.U.
Capacity
4 Gallons
Weight (without battery
10.54 lbs. (4.78 kg)
pack)
Battery Mode
BAF701 and other BAF series
Charge Mode
29482 and other CAF series
12
LIMITED WARRANTY
3
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of three (3)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion, will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been purchased or rented for industrial/commercial use, and
that have been maintained in accordance with the instructions
in the owners' manual supplied with the product when new.
SOLUTION
Charge the battery by
following the proce-
dures in the battery and
charger manual.
Remove battery from
backpack sprayer. Place
battery on charger and
allow to charge for 10
minutes or until the
changing light turns
green. Remove from
charger and install in
backpack sprayer for
use.
YEAR
ANS
AÑOS
EN

Publicidad

loading

Este manual también es adecuado para:

Bps40b210Bsf301