Razor RipRider 360 Manual De Instrucciones página 3

BEFORE YOU BEGIN
Remove contents from box and check parts against part diagram below.
q Estimated Assembly and Set-Up Time
Recommend assembly by an adult with experience in bicycle mechanics.
Allow up to 15–20 minutes.
Front Fork Assembly
Front Wheel Assembly
q Required Tools
ASSEMBLY AND SET-UP
q Attaching Front Fork
Required Tools: 13mm open wrench and 5mm allen wrench
1
Remove steering bolt and
locknut from frame assembly.
Steering Bolt
Spring Washers
Rear Caster Wheels
Pedal
2
Insert front fork into the frame
assembly.
Seat
3
Properly align slot in headset
tube with pin on fork.
2
WARNING: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RIPRIDER 360˚.
The RipRider 360˚ has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible.
WARNING: Failing to
properly tighten the steering bolt
that attaches the handlebars can
cause you to lose control and fall.