Página 1
USER´S Ground SUB10T MANUAL screws 1/4" (6.35mm) Ground SUB10T SPECIFICATIONS MODEL Ground SUB10T Woofer 10''Polypropylene Cone RMS Power 150W Frequency Response(±3dB) 50Hz-300Hz Nominal Impedance Sensitivity IP Level IP 65 Product Dimension(mm) 310x420x420 (12.2"x16.5"x16.5") Please read the manual before using the product CARE AND MAINTENANCE Make sure to turn all equipment off before cleaning.
Página 2
2. Measure the center-to-center distance between the key-hole slots and install two 2. When installing Ground SUB10T speaker outside do not submerge or place them in mounting screws into the deck, leaving 1/4" of the screws exposed above the direct contact with water (e.g., ponds, waterfalls, fountains).
Página 3
MANUAL Ground SUB10T DE USUARIO tornillos 1/4" (6.35mm) Ground SUB10T ESPECIFICACIONES MODELO Ground SUB10T Altavoz de graves Cono Polipropileno 10'' Potencia RMS 150W Respuesta de frecuencia (± 3dB) 50Hz-300Hz Impedancia nominal Sensibilidad Nivel IP IP 65 Dimensión del producto (mm) 310x420x420 (12,2"x16,5"x16,5")
Página 4
2. Mida la distancia de centro a centro entre las ranuras de ojo de cerradura e 2. Cuando instale el altavoz Ground SUB10T en el exterior, no lo sumerja ni lo coloque instale dos tornillos de montaje en la plataforma, dejando 1/4" de los tornillos en contacto directo con el agua (por ejemplo, estanques, cascadas, fuentes).