Publicidad
Idiomas disponibles
Idiomas disponibles
Suspected malfunctions are often due to causes that the users can fix themselves. Therefore, check the product using this
section. In most cases the problem can be solved quickly.
PROBLEM
Product does not
start
Product does not
reach full power
Result is
unsatisfactory
Vibration or noise is
excessive
Product suddenly
stops
WWW.SENIXTOOLS.COM
TROUBLESHOOTING
POSSIBLE CAUSE
Battery pack not properly attached
Battery pack capacity too low
Battery pack damaged
Switch trigger not set on ON position
Battery pack capacity too low
Air vents are blocked
Cutting attachment is worn
Bolts/nuts are loose
Battery pack capacity too low
Battery too hot
SOLUTION
Attach properly
Remove and charge battery pack
Check by a specialist electrician
Refer to chapter "SWITCHING ON/OFF"
Charge battery pack
Clean the air vents
Replace with a new one
Tighten bolts/nuts
Remove and charge battery pack
Remove battery pack and let it cool down
27 - EN
Publicidad
