Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CONNECTION
Before making any connections, switch off all the equipment and disconnect it from the mains.
It is recommended that you read the manual before connecting the equipmen.
1.- Install the satellite dish and position it facing the satellite.
2.- Connect the aerial to the receiver.
3.- Connect the receiver to the TV according to your needs.
4.- Once the connections have been made according to your needs, connect the equipment to the mains
and switch it on.
START-UP
When you switch on the receiver for the first time, a channel list is loaded by default in German. You can
modify this channel list using the Quick Setup screen or by performing a new channel search on the satellite.
NOTE: if you need to change the language go to the third option in the menu VORRANG (PREFERENCES)
> OSD-SPRACHE (OSD LANGUAGE)
QUICK SETUP
1.- Remove channels from the existing list MENU>CHANNEL>DELETE ALL CHANNELS.
2.- Exit the menu by pressing the MENU button on the remote.
3.- To access the quick setup menu, press the L/M button on the remote twice. You can set the language
in this menu, and to create the channel list you will find the following options:
- INDIVIDUAL SATELLITE SEARCH: allows you to search for channels on a single satellite. Select this
option, press the OK button, change the satellite parameters and press the blue button to SCAN.
To finish, select the scan type (automatic, blind, or manual) and press OK to start the search.
- MULTI-SATELLITE SEARCH: allows you to select several satellites to search for channels on all of
them. Select this option, press the OK button, select the satellites with the OK button on the remote
and press the blue button to scan. To finish, select the scan type (automatic, blind, or manual) and
press OK to start the search.
- RESTORE PROGRAM: loads the default channel list (depending on the selected language).
NOTE: this quick setup menu will only appear when there is no channel on the channel list.
- 4 -
Publicidad
