Urbanears Boo Tip Manual Del Usuario página 2

EN

HOW TO PAIR
01. Put both earbuds in the case and keep the lid open.
02. Press and hold the button on the case for 2 seconds. Release it when the LED
indicator blinks blue.
03. Select Urbanears Boo Tip from your device's Bluetooth menu to pair. Done!

TOUCH CONTROL
The touch control surfaces are located on the left and right earbud.
— Tap once to play/pause or accept/end calls.
— Tap twice to skip forward or reject calls.
— Taps three times skip backwards.

CHARGING
Place the earbuds in the charging case and close the lid to charge the earbuds and
turn them off.
Charge the case by connecting a USB charger to the USB-C port on the case.
If left unused, the earbuds will go into standby in order to save power. Just tap both
earbuds to wake them up again.

IN-EAR TIPS
Take the time to find the in-ear tip size that best fit your ear. The tips should fit snugly
in your ear but still feel comfortable.

LED INDICATOR
Blue light is ready for Bluetooth pairing. Red (low) to green (full) is for the case
battery status.
CLEANING
Regularly clean your earbuds to make them last longer and perform better.
Unplug the USB charger before cleaning the case. Make sure everything is
completely dry before putting the earbuds back in the case or plugging in a USB
charger.
Use a soft, slightly damp lint-free cloth and mild soap and avoid getting moist in any
openings. Carefully clean sensitive areas such as speaker mesh and openings with
a dry brush or cotton swab.
Silicone tips can be removed and cleaned with water and mild soap. Dry them with a
towel before putting them back on the earbud.
— Do not use any sharp objects
— Do not rinse the product under running water or use compressed air
— Do not use cleaning detergents or wet wipes as they may contain strong
chemicals, alcohol or bleach that can affect the surface or performance
TROUBLESHOOTING
EARBUDS DOES NOT BEHAVE AS EXPECTED
If your earbuds behave erratic or are unresponsive, follow the instructions below.
01. Put both earbuds in the case and close the lid to restart the earbuds.
If the problem persists, perform a factory reset.
Note: This will delete all user settings and the earbuds will need to be paired again.
01. Put both earbuds in the case and keep the lid open.
02. Press the button on the case and release it when the LED turns purple.
03. Remove Urbanears Boo Tip from your device's Bluetooth menu before pairing
again.
LEFT OR RIGHT EARBUD DOES NOT PAIR
If you can only connect to either the left or the right earbud but not both, follow the
instructions below.
01. Make sure that both earbuds are charged.
02. Remove Urbanears Boo Tip from your device's Bluetooth menu.
03. Put both earbuds in the case and keep the lid open.
04. Triple press the button on the case and the LED indicator blinks green.
05. The LED blinks blue when the earbuds are coupled and are ready for pairing.