CREE LIGHTING RUL-C Serie Instrucciones De Instalación

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. This luminaire must be installed in accordance with the NEC or your
local electrical code. If you are not familiar with these codes and
requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n'êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
3. Suitable for wet locations.
Convient aux emplacements mouilles.
4. Min. 75C supply conductors.
Les fils d'alimentation doivent convenir pour 75C.
5. Suitable for operation in ambient not exceeding 40°C.
Peut etre utilise a une temperature ambiante n'excedant pas 40°C.
6. If mounting bolts are completely removed in the field they should
be hand threaded (prior to use of power tools) to ensure proper
engagement of the thread when re-installing. Failure to pre-start
threads may result in cross-threading or stripping of the bolts during
reinstallation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
1
D-ring Screw
LUMINAIRE INSTALLATION
STEP 1:
To open cover, unscrew the D-ring by hand or using a Torx or flathead
Figure 1.
screwdriver. See
STEP 2:
Slide fixture onto a 1.66"O.D. or 2.38"O.D. pole tenon or mast arm
through opening on the rear of housing. See Figure 2.
STEP 3:
Adjust leveling of fixture from side to side. To level from front to back,
slide pole to different Adjustment Steps in housing. Each step changes
the angle in 2.5° degree increments. See
STEP 4:
Once desired position is achieved, use 9/16" socket wrench to tighten
1 of 2
2
Figure 3.
NOTES:
• For use with 120-277 VAC.
• Nema receptacle has orientation stops incorporated to
®
prevent greater than 360º rotation. Do not force beyond to avoid
damages in the receptacle and/or in the electrical connections
inside the luminaire.
• Prior to installation, store luminaire in a dry location protected
from rain, dust, and outdoor environment. If equipped with a
photocell receptacle, do not store or install luminaire outdoors
without immediately installing a suitable photocell, shorting
cap, or other compatible device. Do NOT leave receptacle open
to environmental elements. Luminaires with a top-mounted
photocell receptacle should not be installed in an up-light
position or at a tilt greater than 45 degrees from the down-light
position.
3
Mounting Bracket
Bolts and Washers
Mounting Bracket
mounting bolts to 150 in-lbs torque See
next page
.
STEP 5:
IMPORTANT - DO NO
T exceed 300 in-lbs torque on the mount
bolts. Exceeding recommended torque value resulting in excessive
deformation of mounting bracket will cause stripping of mount hardware
which could lead to an unsafe mounting condition.
STEP 6:
Reference Electrical Connections section for completing electrical
connections.
STEP 7:
Close door and retighten D-ring closure screw to 25 in-lbs torque.
RUL-C Series
LED Rural Utility Luminaire
Includes 3-Pin Nema
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
Adjustable
Steps
Figure 2 and the table on the
LPN05497X0001A0_B