Publicidad
Idiomas disponibles
Idiomas disponibles
GB
2.3
Device elements
3
Operation
Please always pay attention to the safety information in chapter 1.
3.1
Safety in handling
3.2
Initial operation
1. Insert the mains plug into a protective earth conductor outlet.
2. Switch on the device with the On/Off switch (6) - on the display (5) at
3. Check that the hook nozzle on the heated device is firmly seated during
H1079XM_230117.indd 11
1
2
3
4
5
6
7
8
9
10
Attention!
Observe the following instructions to prevent the risk of injuries and
damage to the device:
1. Never lay down the device on its side in its hot operative state. This
could cause the unchecked leakage of adhesive. Risk of burns/dama-
ge to the device!
2. Never remove the adhesive residues from the melting chamber by
force (e.g. with a scraper or screwdriver). This could damage the inte-
rior lining of the melting chamber.
3. Never loosen „frozen" hot-melt adhesive candles by force (e.g. with
tongs).
4. Use the device only after it has completely heated up, indicated by the
green display.
5. Observe the instructions for Döllken hot-melt adhesive (processing
error avoidance).
6. Never extract the adhesive candle from the device, since this can
damage the transport mechanism!
right.
The display (5) lights up blue.
The device heats up immediately.
To protect the device, the setting keys on the display have no function.
first commissioning - tighten the counter nut, if necessary.
Hook nozzle
Stand
Setting feed switch
Delivery rate switch
Display buttons blocked - device protection
On/Off switch
Power cable
Sensor slot for glue sticks
LED spot light
Integrated signal horn - stick feed
11
Operation
24.01.23 10:22
Publicidad
