Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Making the water supply connections：
Thread the nut (1) on the supply line onto the
outlet of the water supply valve (2) and tighten
with a wrench. Do not overtighten.
Note: The hot side inlet tube is indicated by a label.
Avoid twisting wires together or placing the wires
close to each other and damaging.
OPERATION INSTRUCTIONS
1. Flushing and checking for leaks：
Important: After installation is completed, turn on
the hot and cold water supplies. Check for leaks.
Pull the hose assembly out of the spout and remove
the spray head by unscrewing it from the hose in a
counterclockwise direction. Be sure to hold the end
of the hose down into the sink and turn the faucet to
the warm position where it mixes hot and cold water.
Flush the water lines for one minute. This flushes
away any debris that could cause damage to internal
parts. Check for leaks.
Re-tighten any connections if necessary, but do not
overtighten. Reinstall the spray head by hand tightening
it back onto the spray hose in a clockwise direction.
2. If it is necessary to remove the quick connector (1),
squeeze the tabs (2) on the quick connector and
then pull down to disconnect.
6
1
2
1
2
Squeeze
6
2
Pull
down
1
1
Publicidad
