Publicidad
Idiomas disponibles
Idiomas disponibles
C. Cleaning (Continued)
1. Cleaning the Cover
NOTE: Drying with heat may cause shrinking that affects the covers fit and function.
a. Remove the outer cover from the foam base and zip closed.
b. Machine wash in warm water and tumble dry - no heat. Do not iron. Note - Do not
dry clean covers or use industrial washers and dryers to clean cover. Do not steam
autoclave. Do not bleach.
c. To refit cover after washing, fit cover back over foam base. Ensure the back of the
cover matches up to the back of the foam base. Note - If utilized in an institutional
setting, write the residents name with a permanent marker on the content label of
the cover. This will ensure the return of the correct cover to its matching cushion
after washing.
2. Cleaning or Deodorizing the Foam Base
NOTE: Do not immerse your foam base in any solution.
a. Fill a spray bottle with detergent or deodorizer. Verify that the labeling for the manu-
facturer of the detergent or deodorizing indicates it is appropriate for this use. Follow
the manufacturer's labeling for proper solution concentration and use.
b. Lay the foam base in the bathtub or on a surface that can get wet.
c. Spray the entire surface of the foam base including the sides. Flip it over and repeat
on the bottom. Once you've finished spraying, let the solution set for 20 to 30 min-
utes.
d. Wipe the solution off with a damp washcloth. Do not spray with water.
e. Allow the material to air dry but avoid direct sunlight. Depending on how wet your
foam base is, it may take 24 hours to several days to completely dry. Verify that no
solution remains in the foam base before using.
3. Sanitizing the Foam Base
NOTE: Do not immerse your foam base in any solution.
a. Fill a spray bottle with a 70% or greater alcohol solution.
b. Lay the foam base in the bathtub or on a surface that can get wet.
c. Spray the entire surface of the foam base including the sides. Flip it over and repeat
on the bottom. Once you've finished spraying, let the solution set for 20 to 30 min-
utes.
d. Wipe the solution off with a damp wash cloth. Do not spray with water.
e. All the material to air dry but avoid direct sunlight. Depending on how wet your foam
base is, it may take 24 hours to several days to completely dry. Verify that no solution
remains in the foam base before using.
9
Publicidad
