Publicidad
Idiomas disponibles
Idiomas disponibles
PWS 0166
is not suitable for places constantly exposed to humidity).
•
Do not place the fan near flames, cookers or heaters.
•
Do not obstruct the air flow.
ASSEM BLE
•
Remove the screw from bottom side of mast. Place mast on base and screw it by bottom side of the
base.
•
Put the fan motor on motor support of top of mast and fit it with the screw.
•
Place the rear grill in front of motor and screw it. Put the blade in the motor shaft and assure it
tightening its screw. To fix the front grill it is just necessary placing in front of rear grill and adjusts it
with flanges of the frame.
•
To amend the height of the fan just have to loosen up the screw which is perpendicular to mast and
go up or go down until get the desired height. After that tighten the screw again.
OPERATING INSTRUCTIONS
• Step 1
: Set the fan base on a level and stable surface.
• Step 2
: Please make sure the Speed knob is in the 0 position. Plug cord into any standard AC outlet.
• Step 3
: The speed is adjusted by moving the knob left or right to the desired setting (0-Off; 1-Low; 2-
M edium; 3-High)
• Step 4
: To connect swing function, unscrew the screw on bottom of motor and change of position as
below pictures show.
No swing
•
If you want to amend the tilt of fan head, loosen up a bit the screw on joint of motor head and mast,
move motor head to desired tilt and tight again the screw.
FAN STORAGE
The fan can be stored in the off-season completely assembled or partially disassembled. It is important that
store place is dry and safe.
•
If you store it disassembled, we recommend using original box, or at least a box with appropriated
dimensions.
•
If you store it assembled or partially disassembled, cover the fan head to protect from dust.
•
You always must empty water tank if you aren't going to use the fan for more than a week.
Swing
9
Publicidad
