Nulaxy KM28 Manual Del Usuario página 7

Bluetooth Power Failure BASS Reduces Noise
Version : 5.0 Memory Function During the Call
User's guidance
Step1. Install the air outlet bracket.
1. Put the threaded knob on the end of the air outlet bracket.
2. Insert the air outlet bracket into the round hole at the back of the transmitter. Then screw
the thread tightly.
3. Attached the air outlet bracket to the car air vent, tighten the screws to the best strength,
adjust the angle of the machine.
Step2. Connect the car charger to the cigarette lighter.
1. Make sure the cigarette lighter isn' t rusty before plugging it in because it might not be
connecting to the transmitter well. Please remove any rust or connect it to a different vehicle
to see if it works.
2. The KM28 screen displays the current voltage of the car battery after it has been plugged
in. After that, the pairing state takes two seconds to enter.
Step3. Set the blank frequency of your car stereo between 88.1 and 107.9 MHz.
Note:
1. The FM frequency range is 88.1-107.9 MHz in the United States and Canada. The FM
frequency range in the United Kingdom is 87.5-108.0 MHz.
2. The frequency at which there is only "rustling" and no human voice or music is called the
blank frequency.
Step4. Change the frequency of the KM 28 Transmitter to match that of the car stereo.
1. The number flashes when you long press the "CH-" or "CH+" button to enter FM mode and
adjust to the same frequency as the car stereo.
For example, If FM88.8 is a blank channel on your car stereo. Press the " CH-" or "CH+" button
or turn the "Spin Button" on KM28 to change your KM28' s frequency to FM88.8.
2. Subsequent to setting, the vehicle sound system has no rustling or other noise, you can
begin to enjoy the FM radio or music.
05