Publicidad
Idiomas disponibles
Idiomas disponibles
CVS-MW1-4Y IB-080421-FINAL.qxp_MLU3AC1-JAN05-2 8/9/21 12:58 PM Page 28
Other possible errors and their solutions
If problems occur when using the device, the following points should be checked
and, if necessary, the corresponding measures are to be taken:
Malfunction
The display remains blank when the
instrument is switched ON although the
batteries are in place.
The pressure does not rise although the
pump is running.
The device frequently fails to measure
the blood pressure values, or the values
measured are too low or too high.
Every measurement results in different
values, although the device functions
normally and normal values displayed.
The blood pressure values differ from
those measured by my doctor.
After the instrument has inflated the cuff
the pressure falls very slowly or not at
all. (No reasonable measurement possible).
28
Remedy
• Check battery installation.
• If the display is unusual, remove the
batteries and then exchange them for
new ones
• Check polarity
• Check the connection of the cuff tube
and connect properly.
1. Fit the cuff correctly on the arm. (see 5.3)
2. Before starting the measurement make
sure that the cuff is not too tight and
that clothing is not exerting pressure on
the arm. Take off articles of clothing if
necessary.
3. Measure blood pressure again in
complete peace and quiet.
• Please read the following information
and the points listed under "Common
sources of error".(5.2) Repeat the
measurement.
Blood Pressure changes constantly. The
observed readings may accurately reflect
your pressure.
• Record daily values, consult your doctor.
• Pressure readings in your doctor's office
may be higher due to anxiety.
• Your blood pressure fluctuates through-
out the day so record the time along
with your reading.
• Check cuff connections.
Ensure the unit has not been tampered with.
Publicidad
