DAY Useful Everyday 74592 Manual De Instrucciones página 28

BEFORE USE
Before connecting the power cord,
please put the machine upright for 24
hours to allow the refrigerant to settle.
Unpack all packaging materials: foam,
bags, tape, etc.
The machine should be placed on a
stable level to support the weight of the
ice machine and its contents.
This machine can be installed without
any support and can be installed in any
place that meets the conditions of use
and power.
Use a machine in a place that is well
ventilated and has a temperature
between 10°C and 40°C. Do not install
or operate the machine in a sealed
space, such as a closed room.
To ensure long-term use of the
machine, use filtered or potable water;
or use citric acid every other week to
clean the outside of the machine and
the dust deposits on the bottom of the
tank.
USE
When using for the first time (or
not used for a long time), it is
recommended to discard the ice cubes
made in the first 4 cycles to ensure that
the machine is thoroughly cleaned.
Insert the plug into a wall socket.
Open the front cover, take out the ice
basket (1), and pour potable water into
the water tank (3) (Do not exceed the
MAX water level mark).
Put back the ice basket (1). Make sure
the water level is below the bottom of
the ice basket (1), and then close the
front cover.
After plugging it in, the machine is
in standby mode with the "POWER"
indicator (F) flashing green and the
"SMALL" indicator (A) will light up
green.
Press the "ON/OFF" button (D) once, the
appliance will start working in small ice
cube mode by default, and the "SMALL"
indicator (A) will light up green.
During the ice making cycle, press
the "SELECT" button (E) to switch to
large ice cube mode; the "LARGE"
indicator (B) will light up green. The
appliance has a power-off memory
function. The previously running mode
before power-off will be automatically
resumed when powering on.
During the ice making cycle, press
the "ON/OFF" button (D) once, the
appliance will stop working and the
"POWER indicator (F) will flash green.
In the standby mode, press and hold
the "ON/OFF" button (D) for 5 seconds,
the appliance will enter self-cleaning
mode, and the "CLEAN" indicator (C)
will light up red.
After 15 minutes, the appliance
switches to standby mode, and the
"POWER" indicator (F) will flash green.
When the ice basket is full, the machine
will stop automatically and stand by.
The ice maker can partially block heat
and store ice temporarily but cannot be
used as a freezer.
Please remove ice cubes as needed and
add water to ensure the machine works
normally.
When the ice box is full, the "ICE FULL"
indicator (H) will light up red, and the
machine will stop automatically. When
the ice is removed, the machine will
restart.
If the water level is too low, the "ADD
WATER" indicator (G) will light up red
and the ice maker will stop working.
After refilling, press the "ON/OFF"
button (D) to restart.
When you do not use the ice maker,
please turn off the machine and unplug
the power cord.
28