Publicidad
Idiomas disponibles
Idiomas disponibles
- With soft water, at least once every 3 months.
- With hard water, at least once every month.
If doubt to the water hardness, ask advice of your local tap water company.
It is recommended to use only liquid descaler suitable for coffee maker, and read care-
fully the instructions on its package or user manual before use.
1. Mix adequate descaler with cold water in a measuring jug.
Note: Never use a powder descaler.
2. Fill the water tank up to the Max level with prepared solution.
3. Operate the appliance until the water tank is empty as if you brewed coffee, but
without paper filter and ground coffee in the filter holder.
4. Repeat steps 1 to 3 for another descaling cycle.
Note: Never refill the water tank with the used descaling solution because it is no
longer active.
5. Operate two more brewing cycles with fresh, cold water to remove all descaler
solution residues.
Important:
1) Never interrupt the descaling process.
2) Malfunctions caused by scale deposited inside the appliance are not covered
by the guarantee if the descaling process is not carried out properly.
Troubleshooting
If you have a problem, you may find the solution in the table below. In case these
solutions can not solve your problem yet, please contact with the nearest authorized
service agent for examination, repair or adjustment.
PROBLEM
The appliance does not
work.
Water leaks out of the
appliance.
The appliance produces
a lot of noise and steam
during brewing.
10
SOLUTION
- Make sure the voltage indicated on the appliance
corresponds to the local mains voltage.
- Make sure the appliance has been plugged in &
switched on.
- Check if the water tank is filled beyond the MAX level.
- Make sure the water tank is not filled with hot water.
- The appliance needs to be descaled (see chapter
'Descaling').
INGLÉS
Publicidad
