Scosche TAPSTICK BTRP Manual Del Usuario página 3

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This device must not be co-located or operating in conjunction with any o1her
antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful Interference to radio communications. However, there Is
no guarantee that interlerence will not occur in a particular installation. If this
equipment does cause harmful inter1erence to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the inter1erence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC's RF radiation exposure limits for general population/
uncontrolled exposure, this device must be installed to provide a separation
distance of at least 20cm from all persons.
WARNING: Any changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to operate
the equipment.
This device complies with Industry Canada licenc&-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause inter1erence, and (2) this device must accept any inter1erence,
including interference that may cause undesired operation of the device.
a
The device is compliance with RF field strength limits, users can obtain
Canadian lnfom,atlon on RF exposure and compliance.
This Class B digital apparatus complies with Canadian ICES-003.
This product bears the selective sorting symbol for Waste electrical
and electronic equipment (WEEE). This means that this product must
be handled pursuant to European directive 2012/19/EU In order to be
recycled or dismantled to minimize its impact on the environment. User
- has the choice to give his product to a competent recycling organization
or to the retaller when he buys a new electrical or electronic equipment.
FCC STATEMENT
IC STATEMENT
RECYCLING
3