Yumpu TWINDOSE 20 EM Manual De Instalación página 5

1.4

pressure for the rinse pump.
GETTING

STARTED

Installation
meter. Application of incorrect voltage will permanently damage the unit and is not
covered under warranty. Avoid wiring to any power source that has large fluctuations in
voltage and/or is prone to surges. Refer to the wiring diagram in this manual for all power
Set Up &
and signal connections.
Operation

Maintenance &
the three available input voltages (115 - 230 Vac) of the transformer inside the TWINDOSE
Accessories
20 EM.

Troubleshooting
Always disconnect power when servicing the unit.

warewasher.

persons or things or the incorrect functioning and damage to parts of the equipment.
TWINDOSE 20 EM
WARNINGS
Check pressure at the rinse injection point in respect of the max-recommended
Check suction tubes are inserted in the correct product tanks (supply containers).
All electrical connections to the TWINDOSE 20 EM should first be verified with a
Check the voltage of the main power source and make sure that it matches one of
CAUTION: The TWINDOSE 20 EM has high voltage connected to the transformer.
CAUTION: During installation and electrical connections remove all power from the
Non-compliance to any of the dispositions hereby contained may cause damage to
Rev. 1.0 code 0000138870 3