Publicidad
Idiomas disponibles
Idiomas disponibles
VIDEOS
Need help with the installation? Be sure to watch our
installation videos which can be found on
http://www.doorbird.com/support
INSTALLATION
All the steps below should be carried out carefully
by a competent adult, taking into consideration
any applicable safety regulations. Please contact us
directly or seek the advice of a competent specialist.
Please ensure that all wires used for the
installation are undamaged along their entire
length and approved for this type of use.
1
SWITCHING OFF POWER
Switch off the power to all wires leading to
the assembly location, i.e. the door chime,
electric door opener, power supply unit for
the video door station etc.
3
MOUNTING THE DEVICE
The device can be mounted on the wall using the wall mount bracket, screws and dowels supplied with it or on
DIN-Rail using the DIN-Rail adapter supplied with it.
Option 1
WALL MOUNTING
Ensure to hit no objects (e.g. cables) when drilling the holes.
If the wall of the house is not made of wood, you
should drill dowel holes 5 mm in diameter in the
wall and then place the dowels provided into the
boreholes. If the wall of the house is made of wood,
you will usually not require any dowels. There are
special dowels for assembling the device on an
insulating wall, e.g. Fischer insulating dowels. Please
check with your insulating material manufacturer
regarding which dowels they recommend.
6
Network speed and network components
Please ensure that the upload speed of your Internet
connection is at least 0.5 Mbps. The user experience is
only as good as your network speed, network stability
and quality of your network components, such as
your Internet Router and WiFi access points or WiFi
repeaters. Please also make sure that your network
components are no older than two years old, have
been manufactured by a well-known manufacturer,
and have the latest firmware installed.
Should these requirements not be fulfilled, it may
occur, for example that the performance of audio and
video is poor or push notifications are delayed or do
not arrive on your smartphone or tablet at all.
Requirements:
High-speed Internet (via landline): DSL, cable or optical
fibre
Network: Ethernet with DHCP
2
DETERMINING THE ASSEMBLY
LOCATION
The device is IP30 certified (not water-proof).
Please make sure to put the device into an
appropriate housing if you want to use it
outdoors.
The network cable between the device and the
PoE-Switch/PoE-Injector/ Internet Router can have a
maximum length of 80 meters/262 feet.
Publicidad
