Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
SET UP AND ADJUST THE TRIPOD (FIG 2)
1. Loosen the tripod locking knob (F).
2. Push down the leg connector (A) until the legs (B) are fully extended
and firmly tighten the locking knob (F).
3. Adjust the height of the tripod by unlocking the flip locks (C1 & C2)
and raising the center poles (D1 & D2) of the tripod. Lock the flip locks
when the tripod reaches the desired height.
NOTE
: The maximum height of this tripod is 70".
4. Loosen the twist collar (C3) and adjust the extendable leg (B2) to level
the tripod on uneven surfaces. Tighten the collar (C3) after leveling.
ATTACH THE CARRYING HANDLE TO THE
STAND (FIG 2)
1. Place the carrying handle (1) vertically on the stand (7).
2. Use two hex screws (10), flat washers and spring washers to secure
the carrying handle on the stand as shown in FIG 2.
ATTACH THE WORK LIGHT HEADS TO
THE STAND (FIG 2, 3)
1. Place the stand (7) on a flat surface.
2. Use the locking knobs (8), flat washers and spring washers to secure
both work light heads on the sides of the stand as shown in FIG 2.
3. Use a twist knob (12) to attach the power cable connector (13) to the
carrying handle as shown in FIG 3.
ATTACH THE WORK LIGHT ASSEMBLY TO
THE TRIPOD (FIG 2, 4)
1. Place the work light assembly on the top of the tripod. Insert bottom
ends of the two Hex screws (10) into two holes on the supporting
bracket (E).
2. Use the bracket locking system (E1, E2 and E3) to secure the work
light assembly to the tripod as shown in FIG 4.
English
FIG 2
FIG 3
FIG 4
4
2
8
E1
7
E3
E2
A
B
F
1
12
13
E1
1
2
8
10
E
D2
C2
D1
C1
B
C3
B2
E2
E3
Publicidad
