Homelite HOMCS01 Manual Del Operador página 14

DANGER:
Never cut near power lines, electric cords, or other electric
sources. If bar and chain jams on any electrical cord or
line, DO NOT TOUCH THE BAR OR CHAIN! THEY CAN
BECOME ELECTRICALLY LIVE AND VERY DANGEROUS.
Continue to hold the pruning saw by the insulated rear
handle or lay it down and away from you in a safe manner.
Disconnect the electrical service to the damaged line or
cord before attempting to free the bar and chain from the
line or cord. Contact with the bar, chain, other conductive
parts of the pruning saw, or live electric cords or lines will
result in death by electrocution, electric shock, or serious
personal injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Head protection should be worn when making cuts
overhead. Failure to do so could result in objects being
thrown into your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Never cut a log or limb that has a diameter greater than the
length of the guide bar. Only properly trained profession-
als should perform these cuts. Performing these types of
cuts can cause an accident and result in death or serious
personal injury.
OPERATION
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced. Please contact customer service or an autho-
rized service center for assistance.
APPLICATIONS
You may use this product for the following purposes:
 Basic limbing and pruning.
CHARGING THE TOOL
See Figure 5.
 Make sure the switch trigger is locked out in the off
position.
 Insert the charging cable into the product as shown.
 Connect the power adapter to an outlet providing normal
household voltage, 120 volts, AC only, 60 Hz.
 When the tool is charging, the LED will turn red.
 Do not place tool in an area of extreme heat or cold. It
will charge best at normal room temperature.
 If the LED does not turn on after connecting to a power
supply, check connections. If all connections are secure,
remove from power supply and recheck after one hour.
 After charging is complete, the LED will turn green.
 If LED does not turn to green after three hours, an error
has occurred. If all connections are secure, remove from
power supply and recheck after one hour.
 Disconnect the power adaptor from the outlet once the
tool is fully charged and ready for use.
 Disconnect the charging cable from the tool.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked with hands free of the
lock-out button when not in use.
WARNING:
Do not use charger outdoors or expose to wet or damp
conditions. Water entering charger will increase the risk
of electric shock.
Page 10 — English