Publicidad
Idiomas disponibles
Idiomas disponibles
8. OPERATING INSTRUCTIONS
Charging the battery
The battery pack for this tool has been shipped in a low charge condition and must charged fully
charged before the first use. To obtain maximum energy, ensure the batteries are fully discharged of
all power before re-charging for the first 5 or 6 charges. The batteries must also be charged for a full
hour during this time.
1. Remove the battery pack from the drill. To do this press both battery release buttons simulta-
neously and pull down.
2. Place the charging stand onto a bench or table near a power supply point.
3. Push the charging plug of the AC adaptor into the battery.
4. Connect the AC adaptor to the power supply point. The light will be red when unit is plugged in
and during the battery pack is being charged.
5. When the battery is full charged, the red light turns to green.
Selecting correct driver bit/socket bit
1. Always use the correct size driver bit/socket bit. Use only the driver bit/socket bit shown in below
picture. Do not use any other driver bit/socket bit.
2. An incorrect size bitt will result in inaccurate and inconsistent fastening torque and /or damage to
the bolt or nut.
Installing or removing driver bit
1. To install the driver bit, pull the sleeve in the direction of the arrow and insert the driver bit into the
sleeve as far as it will go.
2. Then release the sleeve to secure the driver bit.
3. To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out.
Switching on/off
The impact driver is started and stopped by depressing and releasing the ON/OFF switch trigger.
Switch lock
4. The switch trigger can be locked in the center position.
5. This helps to reduce the possibility of accidental starting when not in use.
6. To lock the switch trigger, place the direction of rotation selector in the center position.
Direction of rotation
1. Direction of rotation is controlled by the direction of rotation selector located above the switch
trigger.
2. Clockwise rotation—right: to select forward rotation, release the on/off switch and push the
7
Publicidad
