Crude Steel CX604c Manual De Instrucciones página 6

SAFETY PRECAUTIONS
This appliance is for household use.
Ÿ
Connect the blender into a wall outlet with the same voltage as specified on the back of
Ÿ
the head unit (5) or specified in this manual (page 2).
Switch off the appliance by turning the speed switch (6) to "0" before unplugging.
Ÿ
Unplug from outlet when not in use and before carrying out cleaning. Do not separate the
Ÿ
parts if necessary.
Always unplug by pulling the plug, not the cord.
Ÿ
Never push the main unit, or plug in water or other liquid.
Ÿ
The blades are very sharp. Use extreme caution when handling. Especially when
Ÿ
removed from the jar and during cleaning.
Do not put your hands and / or utensils near moving blades and never press the ignition
Ÿ
while he proceeds to connect the outlet.
If the power cord is damaged, it must be replaced by the manufacturer or authorized
Ÿ
service.
Always keep the device out of reach of children.
Ÿ
Avoid using the device (including children) to people with mental health problems or
Ÿ
reduced mental faculties.
Avoid the power cord comes into contact with sharp edges or sharp and stay away from
Ÿ
hot surfaces or objects.
If using an extension cord, must be equal gauge or greater to maintain the necessary
Ÿ
power and prevent overheating of the cable due to danger of fire.
Protect the environment:not dispose of household
waste products. Please return the electric elements in the
set points for collection.
MOUNTING
1. Place the glass jar (3) on the main unit (5) of the blender.
2. Turn the jar slightly in the opposite direction clockwise and check that you can not
remove the jar from the main unitl (5).
3. Make sure the device is in off mode "0" before plugging.
4. Plug the cable to the mains.
5. Turn the speed switch (6) to P (pulse) for 1 second, to verify proper installation.
¡Warning! This appliance has a safety device will not work if the jar is not properly
seated in the main unitl. Otherwise you must remove the pitcher, then repeat from
step 1.
¡Warning! Never use the blender empty. Only for this test case "for 1 second".
6
All manuals and user guides at all-guides.com
GB