American Gardener Clip&Shear 900054 Manual De Instrucciones página 2

Full Two Year Warranty Extension Handle
If this Extension Handle fails due to a defect in material or workmanship
within two years from the date of purchase, American Gardener, at its sole
discretion, will repair or replace the unit free of charge. Proof of purchase
is required to validate the warranty period. This warranty does not cover
normal wear items such as blades and batteries. For more specific infor-
mation on these wear items please refer to the Service section of this
manual.
To obtain warranty services or questions please call (800) 637-2867.
This warranty applies only while this Extension Handle is used in the
United States.
This warranty gives you specific legal rights, and you may also have other
READ ALL INSTRUCTIONS
rights, which vary from state to state.
ASSEMBLY – Put the two ends of the
shaft together by depressing the spring
buttons and locking them into the holes.
USE – This extension handle should
only be used with the American Gar-
dener Shears (900054, 900056). To
attach a shear to the Extension Handle,
line up the grooves on the shear with the
tracks and slide unit in until it locks. To
release the shear depress the button on
the bottom to release locking tab and
slide unit forward.
To Operate The Trigger Switch:
1. To turn tool ON slide the safety
switch on top of the handle FOR-
WARD with your thumb. Hold it
FORWARD momentarily, while
squeezing the trigger switch (located
under the handle).
2. The trigger has been designed so it is
easy to hold in the ON position dur-
ing clipping. The safety switch may
be released after the trigger switch is
ON.
3. To turn tool OFF, merely release the
trigger. The locking button will snap
backward and prevent the trigger
switch from being accidentally de-
pressed.
DON'T OVERREACH – Maintain
.
proper footing and balance at all times