Installation Instructions - English; General Safety; Electrical Safety - hafele 421.68.205 Instrucciones De Montaje

Installation instructions - English

1. Target group of the installation instructions
The installation instructions are intended for qualified personnel in furniture construction,
such as cabinet makers, joiners and furniture manufacturers.
2. Safety

2.1 General safety

• Do not carry the product by the cable.
• Adhere to the assembly sequence. Do not omit any delivered parts. Do not install any
parts that are not approved by the manufacturer.
• Attach the manual switch inaccessible for children. Verify that children cannot access the
control unit. Install the cables so that children cannot be caught in these or be strangled.
• When installing rotating product versions, verify that sufficient clear space for turning is
available.

2.2 Electrical safety

• Do not install and store product components and cables near hot surfaces, heat sources,
easily flammable materials or areas with direct sunlight.
• Never expose product components and cables to humidity and never install or store near
water as well as damp, aggressive or potentially explosive areas.
• An earthed shockproof socket installed according to national regulations must be
available for the electrical connection. The connection data of the socket must match the
connection data of the product (see chapter "6. Technical data").
• Install product components in such a way that the mains lead can be connected directly
to the socket. The use of distributors or adapters is prohibited.
• Do not trap, crush, kink or damage cables. Do not place cable over sharp edges or
corners. Install cable at a sufficient distance to movable or rotating parts.
• Do not modify or replace plug and cable.
• Clearly and without any strain tie together excessively long cables by using cable ties and
if necessary a strain relief device. The cable routing must be clearly recognisable.
• Do not place cables on the floor. They could become a hazardous tripping risk and
become damaged by being walked on.
3. Correct purpose of use
The product is intended for the following applications:
• Lifting and lowering a flat screen TV at a sufficiently load bearing and stable furniture item
• In dry interior rooms in compliance with the defined limits of the product (see chapter
"6. Technical data")
4. Incorrect purpose of use
The following points are considered improper use:
• Overhead mounting
• Continuous use or overuse: uninterrupted use for more than 2 minutes at full load or more
than 6 minutes per hour.
7