Gatorback Mudflaps 770531 Instructions De Montage página 2

INSTALLATION
(For ease of installation it is suggested that the wheel be removed)
1. Before you install your Mud Flap Set, see the diagram and parts list for all necessary parts.
2. Hold up your mudflap aligning the three lower mud flap holes with the three lower factory holes and mark the fender
through the upper mud two flap holes to indicate where the protective tape (l) and spring nuts (i) will be installed.
3. Pull flap away and install protective tape (l) over the locations you just marked, wrapping the tape around both sides of the
fender.
4. Install spring nuts (i) over the protective tape on the marked locations.
5. Remove the three factory push pins from the lower front of factory guard inside the wheel well, and one factory push pin
from the underside of the quarter panel, closest to the wheel well.
6. Install bracket to factory hole on underside of quarter panel using a cap screw (b) and flat washer (e), and secure using a
nylon washer (j), flat washer (d), lock washer (g) and hex nut (h).
h
g
d
j
e
b