Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Cover the hole in the base of the fountain with
the reservoir lid (D).
8.
cord plug
rate controller on the water pump to
the +/- signs. If the flow is not same for the two outlets,
adjust the knobs on the water flow rate control valve
assembly (C).
CAUTION:
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!
9 . Adjust the feet under the fountain base (B) to make
it level. Place glass beads (F) onto the fountain base
evenly.
of power supply
y
8
D
Hole
Flow rate
C
adjusting
knob
F
Publicidad
