ledscom LC-L-178-WW Manual De Instrucciones página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Remove the glare shield (1) of the light
(counterclockwise).
3. Place the luminaire in the desired
mounting position and mark the drill holes.
4. Drill three 6mm holes at the marked
locations and insert the dowels (2).
5. Guide the connection cable on the
building side through the cable opening
and screw the luminaire to the mounting
position using the screws (3). 2. Connect
the connection cable according to Figure
The cable should not protrude too far into
the luminaire, otherwise shadows may
form.
6. Now close the lamp housing again.
7. Turn the power back on. The installation
is completed.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Damp-proof luminaire (LC-L-178-WW) - Assembly instructions
Figure 1
1: Glare shield
2: Dowel
Figure 2
3: Screws
11/2022