Publicidad
Idiomas disponibles
Idiomas disponibles
8
ENGINE
Perform the following steps to protect the cylinder, piston ring, etc. From corrosion.
1.Remove the spark plug; pour about one table-spoon of SAE 10W-30 into the spark
plug hole and reinstall the spark plug.
2.Recoil start the engine by turning over several times (with 3 in 1 switch knob off) to
coat the cylinder walls with oil.
3.Pull the recoil starter until you feel compression.(This prevents the
cylinder and valves from rusting).
4.Then stop pulling.
5.Clean the outside of engine and spay antirust additive.
6.Store the generator in a dry, well-ventilated place, with the cover place dover it.
7. Lay the engine vertically.
Inverter Generator Owner's Manual
4.Remove the screws, and
remove the cover
5.Drain the fuel from the
carburetor by loosening the drain
screw on the carburetor float
chamber.
6.Turn the 3 in 1 switch to
"OFF".7.Tighten the drain screw.
8.lnstall the cover and tighten
the screws.
9.Turn the fuel tank cap air vent
knob to"OFF"after the engine has
completely cooled down.
33
Storage
Publicidad
