Publicidad
Federal Communications Commission (FCC) Statement - FCC ID: XNAWSD01 / XNAWSM01
15.21 - You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user's authority to operate the equipment.
CAUTION: The equipment may not be modified, altered, or changed in any way without signed
written permission from Withings Inc. Unauthorized modification may void the equipments
authorization from the FCC and will void the Withings Inc warranty.
15.105(b) - The equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. The equipment generate,
use and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. Howeve r, there is no
guarantee that interference will not occur in a particular installation. If the equipment do cause
harmful interference to radio or television reception, which can be determined by turning the
equipments off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: • Reorient or relocate the receiving antenna. | • Increase the separation between
the equipment and receiver. | • Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. | • Consult the dealer or an experienced radio/TV technician for help.
The device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: 1) this device may not cause harmful interference and 2) this device must accept any
interference received, including interference that may cause undesired operation of the device.
FCC RF Radiation Exposure Statement: These equipments comply with FCC radiation exposure
limits set forth for an uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
The device must be installed to provide a separation distance of at least 20cm from all persons.
These device complies with the R&TTE Directive.
A copy of the EU Declaration of Conformity is available online at www.withings.com/compliance
• These appliancescan be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliances in a safe way and understand
the hazards involved
• Children shall not play with the appliances
• Cleaning and user maintenance shall not be made by children without supervision
The socket-outlet shall be installed near the equipment and shall be easily accessible.
FR
Le socle de prise de courant doit être installé à proximité du matériel et doit être aisément accessible.
PT
A tomada deve estar instalada perto do equipamento e deve estar facilmente acessível.
La toma de corriente debe estar instalada cerca del equipo y debe ser fácilmente accesible.
ES
IT
La presa di corrente deve essere installata vicino all'apparecchio e deve essere facilmente accessibile.
XXXXX-XX-XXXXX
Este equipamento opera em caráter secundário, isto é, não tem direito à proteção
contra interferência prejudicial, mesmo de estações do mesmo tipo e não pode
causar interferência a sistemas operando em caráter primário.
WARNING TO USERS IN THE CANADA | IC 11411A-WSD01 / IC 1141A-WSM01
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) the device may not cause interference, and (2) the device must
accept any interference, including interference that may cause undesired operation of the devices.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication. This device complies with Industry Canada RF radiation exposure limits set forth
for general population (uncontrolled exposure).
The device must be installed to provide a separation distance of at least 20cm from all persons and
must not be collocated or operating in conjunction with any other antenna or transmitter.
ATTENTION POUR LES UTILISATEURS AU CANADA | IC 11411A-WSD01 / IC 1141A-WSM01
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) il ne doit pas
produire de brouillage, et (2) l'utilisateur du dispositif doit être prêt a accepter tout brouillage
radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement
du dispositif. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à
l'intention d'autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante. Le présent appareil est conforme aux niveaux limites
d'exigences d'exposition RF aux personnes définies par Industrie Canada.
L'appareil doit être installé afin d'offrir une distance de séparation d'au moins 20 cm avec
l'utilisateur, et ne doit pas être installé à proximité ou être utilisé en conjonction avec une autre
antenne ou un autre émetteur
NOTE TO USERS IN THE EUROPEAN UNION
This device complies with the R&TTE directive. A copy of the EU Declaration of Conformity is
available online at www.withings.com/compliance
This product is not a medical device and should not be used to diagnose or treat any medical condition.
FR
Ce produit n'est pas un appareil médical et ne doit pas être utilisé pour diagnostiquer ou
traiter une pathologie.
PT
Este produto não é um aparelho médico e não deve ser usado para diagnosticar ou tratar
uma patologia.
ES
Este producto no es un dispositivo médico y no se debe utilizar para diagnosticar o tratar
una patología.
IT
Questo prodotto non è un dispositivo medico e non deve essere usato per diagnosi o
trattamento di malattie.
Publicidad
