Publicidad
Idiomas disponibles
Idiomas disponibles
GB
LAWN DETHATCHER
Attachment mounts on the tine shafts and are held in place
with retaining pins. Attachment maintenance is very simple.
Just clean with your garden hose. When dry, spray with a light
pressurized oil like WD40.
The engine will turn the thatching assembly, not the wheels.
The best way to use the dethatcher is to pull the machine
while walking backwards. If you prefer, you can let it run
forward and pull back as if you were tilling; however, this is
slower than pulling the machine while walking backwards.
Dethatching should be done in the spring, late summer, or
early fall.
A complete dethatching in late summer, followed by aerating,
overseeding and feeding will provide a showcase lawn for the
following season.
A – Guard
(410165)
B – Plate
(410166)
C – Wing Nut
(8-53)
D – Flange Bolt
(M9452)
E – Lock Washer
(4029)
F – Dethacher Accessory
G – Retaining Pins
(418-1)
ATTACHMENT LIMITED SERVICE & WARRANTY POLICY
Mantis attachments are guaranteed against defects in material and
workmanship for a period of TWO YEARS FROM DATE OF
PURCHASE.
Any Mantis products or parts found to be defective within the
warranty period are to be returned to our factory listed below.
Transportation charges on parts and units submitted for replacement
under this warranty must be borne by the purchaser.
XP DETHATCHER
1. WARNING! Make sure
tiller is turned off prior to
installation.
4. Slide lower plate (B) down
over tiller fender. Make sure
lower plate (B) is fully
extended over tiller fender.
7. Insert retaining pin (G)
into tine shaft to secure
dethatcher accessory (F).
Repeat on other side.
491
497
102B
418-1
410102
410100
489-1
496
2. Insert flange bolts (D) through lower
plate (B) and guard (A). Place lock
washer (E) over flange bolt (D).
Loosely screw on wing nut (C) and
repeat on other side. Do not tighten.
5. Holding flange bolt (D)
tighten wing nut (C).
Repeat other side.
THIS WARRANTY shall not be effective if the product has been the
subject of misuse, negligence or accident or if the product has been
repaired or altered outside of our factory in any respect which
affects its condition or operation.
Mantis shall not be liable for any special indirect or consequential
damages arising from defective equipment. Any implied warranty,
including merchantability or fitness for a particular purpose, shall
not extend beyond the written warranty period.
P/N 410732 10/22 • © 2022 Schiller Grounds Care, Inc. All Rights Reserved.
P/N 410732 8/11 • © 2011 Schiller Grounds Care, Inc. All Rights Reserved.
L.H. THATCHER
R.H. THATCHER
ASSEMBLY
ASSEMBLY
410107
410108
102B
490
114C
489-2
114D
493
114C
493
328
490
3. Align assembled guard so it is
centered on tiller fender. Slide
assembled guard down over the
tiller fender tab.
6. The dethatcher (F) marked
with an "R" goes on the right
and "L" goes on the left. Align
the hub with the tine shaft
and slide dethatcher accessory
(F) onto tine shaft. Repeat for
other side.
491
497
418-1
410103
410100
Publicidad
