Portable Winch 600MH-Li Guia Del Usuario página 21

DO NOT PUSH THE BLADE AGAINST THE OBSTACLE IN
AN ATTEMPT TO TRY TO CUT OR DISPLACE IT.
1) Release the traction handle (Figure 1);
2) Push the handle upwards, trying to keep the blade and
the wire guide in the soil (Figure 2, A);
3) Lightly press on the traction handle to pass over the
obstacle (Figure 2, B);
4) Lower the machine so that the frame is parallel to the
ground (Figure 3, A);
5) Resume the job by pressing the traction handle (Figure 3, B).
1 2
3.9 Insertion of perimeter wire in a tight corner
When designing the Perimeter Wire Machine 600MH- Li
feature has been implemented to allow burying of the wire as close
as possible to the perimeter of the field and to avoid having to
manually bury the wire. Its compact size and the 15 cm blade offset
from the outside of the wheel are good examples. The handle is
also designed to quickly and easily pivot as needed to turn tight
corners.
Follow the steps below :
A
A B
3
1) Move as far as possible into the
1
corner (See distance recommended
by the manufacturer);
2) Loosen the clamping lever
2
on the handle;
3) Lift the handle until vertical;
3
4
4)Turn the machine in the desired direction by grasping the arch;
B
TM
, every
3.10 Transport
5) Lower the handle until
5
horizontal;
6) Place your left hand on the arch
6
and your other hand on the
traction lever. Move the machine
forward until there is enough
room behind to resume the
normal working position.
7) Once out of the corner, move
7
the handle to the
position to continue burying the
wire.
The best way to transport the
600MH-Li is to fold the handle
forward parallel to the ground.
With the foot stand folded, tilt the
machine down until the handle is
on the floor of the transport
vehicle. Secure it with a ratchet
strap.
EN
desired
6