Emerio CME-122933 Manual De Instrucciones página 6

CME-122933
PARTS DESCRIPTION
1. Top cover
2. Tray
3. Power on/off switch
4. Reservoir with water
level indication
5. Jug
6. Brewing chamber
7. Filter basket
8. Reusable mesh filter
9. Lid of jug
10. Anti-drip function
OPERATION
Before first-time use:
•
Before using this device for the first time please carefully rinse all detachable components with warm
water.
•
Fill the reservoir with cold water to the maximum water level indication.
•
Afterwards brew water twice without coffee powder.
To percolate coffee:
1. Fill the reservoir with cold water.
2. Open the top cover and fill the reservoir to the desired water level indication. The maximum capacity is
1.25L (approximately 10 cups).
3. Place the reusable mesh filter into the filter basket and place the filter basket into the brewing chamber.
Use the measuring spoon to add the amount of coffee powder appropriate to the amount of cups you want
to brew. Close the top cover.
4. Now place the jug on the tray of the appliance. Make sure the lid of jug is closed in order to unlock the
anti-drip function.
Note: The appliance is designed with an anti-drip function. You can temporarily remove the jug and pour
out coffee during brewing cycle without coffee dripping from the appliance within 30 seconds.
5. Plug the power cord into an appropriate outlet. Press the power on/off switch to start brewing coffee.
6. Remove out the jug to serve when finish brewing (about one minute later after the coffee stops dripping
out.).
7. If you leave the device switched on, the tray will keep the coffee warm after finishing brewing. The whole
working process will last 40 minutes. After 40 minutes the unit will be automatically shut off and stop
working. You can manually press the power switch again to switch on the appliance.
8. Always turn off the appliance and disconnect the power supply when not in use.
CAUTION! When pouring coffee from the jug, pour it slowly. Do not incline the jug suddenly in a large tilting
angle, in case the hot coffee flows out from the lid rim and hurt people. Do not put an empty jug back on the
hot warming tray.
Descaling:
•
Regularly descale the coffee maker. The intervals of descaling depend on the water hardness and frequency
of operation. In case of average water hardness we suggest descaling every 3 or 4 months. Please use a
commercially available decalcification agent.
- 5 -
EN