Oxybul FREE BUT 0660937 Manual De Instrucciones página 2

BEFORE FIRST USE, READ CAREFULLY THE INSTRUCTIONS FOR ASSEMBLY AND USE
ASSEMBLING THE SCOOTER
1
Insert the handlebars into the hole at the front of the board, between the 2 front
wheels, respecting the direction of insertion.
2
Make sure the spring-loaded button is springing properly and screw the part on
correctly, as shown.
REMOVE THE SCOOTER
In order to release the rod again, press the snap lock (below the deck) again and easily
pull out the rod.
Adjustable handlebar height
Open the quick-release lock and pull out the
handlebar stem until the automatic latch engages.
Then close the quick-release again. The clamp
tension of the quick-release lock can also be
adjusted by tightening or loosening the securing
nut.
Adjusting the maximum steering angle
The maximum steering
angle can be adjusted to
facilitate your child's
scooter driving.
You have to pull two
knobs towards you and at
the same time, set the
spacing to the outer
wheel, by pushing the
latter either to the left or
right.
Please, ensure that this
subsequently re-engages.
For assembly by an adult (Keep this information for future reference)
- Warning! Use only under adult supervision.
- Warning! Do not use on public roads.
- Use the product on smooth, even surfaces.
- Use the product with care given the level of skill required to avoid falls or collisions liable to harm the user or third parties.
- Do not use the product near hazardous places such as slopes, stairs, swimming pools etc.
- Do not use on damp or oil-stained ground, gravel, patches of ice or uneven, paved surfaces.
- Do not use on steep slopes.
- Children using the toy must be wearing closed shoes.
- Before using, check that the di erent materials are in good condition, fit for use and well maintained.
- If you notice a fault, do not use the product.
- Do not modify the product design at the risk of impacting its safety.
- Failure to follow the instructions may cause a fall, tipping or damage.
1
IMPORTANT INFORMATION FOR USE
1.
move forward. Move carefully at first.
2. Braking: there is a brake at the rear, press down on this with your heel, when
necessary, to slow down. You must push down on this gradually to avoid skidding or
losing stability.
3. It is obligatory to wear shoes and we strongly advise you to wear trousers and
long-sleeve shirts to avoid injuring yourself when you fall.
4. Explain clearly to your child how to lock the scooter before each use.
2 5. To turn, gently tip the handle bar to the left or right.
Turn right
This needs a bit of practice – Pay attention because you might fall while practicing.
IMPORTANT SAFETY INFORMATION
To reduce the risks of injuries when using the scooter:
1. This scooter is for children aged 3 years and over.
2. Do not change the design of the scooter as this could make it unsafe.
3. For outdoor use only.
4. Check that the screws are tightened properly.
5. Do not use in snow, on wet or oily surfaces, on gravel, black ice, or on unevenly
paved surfaces.
6. Practice on smooth and even surfaces.
7. Avoid steep slopes and maintain a slow speed.
8. Learn to stop safely.
9. The scooter has no lights. Therefore do not use it at night or when there is limited
visibility.
10. For use under adult supervision.
11. Do not allow more than one child to mount the scooter at the same time.
12. Ensure that the various materials are in good condition, and that the conditions of
use and maintenance are respected.
13. Check all of the connecting elements: the brake, the steering column's rapid lock
system; the wheel axles must be correctly adjusted and not damaged.
14. Replace the wheels if they are worn or damaged.
REGULAR MAINTENANCE INCREASES THE SAFETY OF THE EQUIPMENT
1. The bearings: avoid riding the scooter through water, oil or sand, which may
damage the bearings.
2. The wheels: the wheels become worn after a certain time, especially the rear
2.
wheel upon which the brake operates. Regularly check and replace the wheels for
extra safety.
3. Modifying the product: You must not modify the original product in any way, other
than as specified in these instructions for maintenance purposes.
4. Nuts and axles: You should also regularly check these, as they can loosen after a
certain time, in which case you must tighten them again, or they may even lose their
5. Surface wash.
Turn left