CASO DESIGN BBQ Cooler M-R Manual De Instrucciones página 34

13.5.3
The handle installing
The Barbecue Cooler comes with one handle. To install simply screw them to the door
with the supplied screws. To do this, slide the rubber seal on the back of the door to the
side to lay open the predrilled holes. Use the included screws to install the handle on the
door. Then reinsert the rubber seal in the correct position.
13.5.4
To remove a shelf
The storage shelves can be positioned individually by means of the holders. To do this,
please remove the storage shelf, set the desired height by means of the holders, and put
the storage shelf back in place.
► Ensure that the shelves are firmly engaged in place before storing any bottles.
13.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Connect the appliance to a properly installed power outlet with electrical data
corresponding to the rating plate's specifications.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
 This unit is not designed to be installed in an RV or used with an inverter.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
Please note
34