Publicidad
Idiomas disponibles
Idiomas disponibles
8. Intended Use
The electric screwdriver is suitable for the insertion and removal of screws.
9. Operation
For Your Safety
Warning! Switch off before adjusting or cleaning. The bit holder continues to move for a few seconds
after the machine is switched off. Caution! Do not touch the moving bit holder.
Please support and clamp the workpiece properly. Do not use hand to grip or clamp the workpiece, it may cause injury.
- Before Use
Charging Procedure
The battery charger supplied matches to the battery installed in the machine. Do not use other battery
chargers.
If the On/Off switch is subject to continued use, the battery can be damaged.
The charging process starts as soon as the mains plug of the battery charger (6) is inserted in the socket and
the machine is then connected to the battery charger.
The battery charge indicator (7) lights up red to indicate the charging procedure.
During the charging procedure, the handle of the machine warms up. This is normal.
When the charging is finished, disconnect the battery charger from the socket.
Do not use the machine during the charging procedure.
Inserting and Extracting Tool Bits
Important! Always turn off the switch before you change the screw bit to avoid unintentional starting of the
machine. When the machine is completely stopped, insert or extract the screw bit.
On/Off Trigger
Use the On/Off trigger to start the machine and keep holding it for continuous operation.
To switch the machine off, release the On/Off trigger
9
EN
Publicidad
