TABLE OF CONTENTS
1.0 INTRODUCTION
2.0 PACKAGE CONTENTS
3.0 SAFETY NOTES
4.0 CONNECTING THE ANTENNA
5.0 INSTALLATION OF THE ANTENNA
1.0 INTRODUCTION
Thank you for purchasing the STRONG SRT ANT 45 DVB-T/T2 antenna. This antenna has been specially
designed to receive digital terrestrial signals. It can be connected to any Digital Terrestrial Receiver (DVB-T/
T2), and is specially designed for outdoor use. The antenna housing is UV protected and weather-proof
sealed. With the supplied multi-functional mounting material, you can install the antenna on a wall, on
your balcony or on a pole outside the house.
This DVB-T/T2 antenna is an "Active type" antenna, it has a built-in low noise amplifier that amplifies the
received signal for better performance. The antenna therefore needs 5 V power supplied by your terrestrial
receiver, or by an AC/DC adapter (supplied with the antenna).
We recommend that you carefully read this user manual before you install the antenna. This will help you
to get the best performance of your antenna.
Specifications
Frequency range:
Active Antenna Gain:
RF Output Impedance
Power Supply:
2 powering methods:
Special features
Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. LTE is
a trademark of ETSI, all other product names are trademarks or registered trademarks of their respective owners.
© STRONG 2021. All rights reserved.
UHF 470 ~ 790 MHz with LTE filtering
Max. 14 dBi for UHF
75 Ohm
5 V DC / 40 mA via ANTENNA connector of the digital terrestrial
receiver or
6 V DC / 150 mA via External 230 V AC to DC adapter with power
injector
Choice of installation methods: wall-mounted or pole-mounted
installation
Built-in FM and LTE (4G) filter
Weather-proof and UV protected housing
Built-in low noise amplifier technology
Highly directional to optimise accurate pointing to the transmitter
and to reduce pick up of unwanted signals
1
2
2
3
5
1