Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Rear Connections Description
Specifications
Power Handling
Frequency Response
Harmonic Distortion
S/N Ratio
Input Sensitivity
Gain Input Sensitivity
MIC/Line Input EQ
Line Out / Rec Out
Internal Sound Effects
Power Requirement
Consumption
Dimensions/Weight
INCLUDED
Loudspeaker
a. MAIN Pre Amp L-R Output: Line level signal Output for the
pre-amp. Set the signal source from volume master control.
b. Tape out: This output jack sends line level signals for external
devices such as tape deck, portable audio recorder or CD-R.
c. Speaker Jacks: MONITOR & TWO CHANNEL: Each channel
output is rated at 8 ohms. Use either two speaker cabinets at
8 ohms each or only one cabinet at 4 ohm.
d. POWER AC Input & Fuse holder
e. Voltage Selector (AC 115-230V) 50-60 Hz
f. Power Switch: ON/OFF Power switch
Class D power amplifier ( 250W+250W @ 4 ohm / 1
20 Hz - 20 kHz at 1kHz (0dB/-3dB) 1W
<0.02% (1W at 8 ohm)
>78 dB
Mic (2kohm), Line (65kohm) Aux (76kohm)
-44.4dBV to -14.5dBV
High: 12 kHz (+/- 12dB), Low: 80 Hz (+/- 12dB)
Unbalanced Line Out (-20dB)
Digital DSP 16 effects
AC 115/230V - 50/60Hz Selectable
115V (3.8A) - 230V (1.9A)
System:
728 x 559 x 210 mm / 17 kg
Mixer/Ampl:
200 x 559 x 210 mm/
Loudspeakers: 264 x 550 x 210 mm/
2x 3 way full range cabinet: Dual 6.5" Low, dual 2.75" Mid and
single 1" Dome Tweeter, with internal crossover.
1x Dynamic microphone
2x 1/4" to 1/4" speaker cable (6m) + 1x XLR to XLR micro cable (6m)
PAG. 4
IMPORTANT NOTICE: This unit is not designed to
operate below 4 ohms. If you ignore this notice, the
warranty will be void.
6 kg
5.5 kg
User Manual/Manual de Instrucciones
EN
EN
50W+150W @ 8 ohm)
ROADER 408
Publicidad
Tabla de contenido
