Makita HK0500 Manual De Instrucciones página 4

Speed change (Fig. 5)
The blows per minute can be adjusted between 2,000
and 3,500 BPM just by turning the adjusting dial. This
can be done even while the tool is running. The dial is
marked 1 (lowest speed) to 6 (full speed). Refer to the
table below for the relationship between the number set-
tings on the adjusting dial and the blows per minute.
Number on adjusting dial
6
5
4
3
2
1
Operation
Position the bit at the location to be chipped, then pull the
trigger.Apply slight pressure on the tool so that the tool
will not bounce around, uncontrolled. Pressing very hard
on the tool will not increase the efficiency.
NOTE:
When removing tiles with a scaling chisel, apply the
chisel to the bottom of tiles as shown in Fig. 6. If you
operate the tool with the chisel applied to the top surface
of tiles, the service life of the chisel will be shortened.
(Fig. 6)
4
Blows per minute
3,500
3,200
2,900
2,600
2,300
2,000
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
ACCESSORIES
CAUTION:
These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. The accessories or
attachments should be used only in the proper and
intended manner.
• Bull point
• Cold chisel
• Scaling chisel
• Safety goggles
• Hammer grease (30 g)