Publicidad
Idiomas disponibles
Idiomas disponibles
EN GETTING STARTED
household vacuum's soft brush accessory. Test the smoke
alarm after cleaning. Never use water, cleaners or solvents
since they may damage the unit.
lf the smoke alarm becomes contaminated by excessive
dirt, dust and/or grime, and gives unwanted alarms,
replace the unit immedialely.
§ 6 Function Description
Low voltage alarm: When the built in battery voltage of the
smoke detector is below 2.7V, the red indicator light flashes
once every 50 seconds, accompanied by a 'Di' sound. The app
will (also) show a warning in the status bar.
Smoke alarm fault: The LED of the smoke alarm flashes once
every 8 seconds and is accompanied by a buzzer. The App
status displays an alarm fault.
If the device operates normal, the red LED indicator flashes
once every 50 seconds.
Wifi Module batteries: The battery life of the base batteries
is 3 years. If the power indicator in the App turns red you
need to replace the batteries in the Wifi Module to ensure
communication is maintained.
§ 7 What to do in case of a fire
Contact your local fire department for what you can do in
case of a fire.
§ 8 Trouble shooting
Reset procedure: If the device fails to access the network or
crashes due to incorrect operation, please unscrew the wifi
module and press the reset button to restart the installation
procedure.
Problem: Red LED flashes and the alarm sounds one beep
every 50 seconds
Solution: The alarm module battery has ran out, replace
the unit.
Problem: No response during APP operation
Solution: Check that the network and the power supply are
normal.
Problem: the APP battery indicates red
Solution: The Wifi Module battery is exhausted. Please
replace the batteries.
Problem: Smoke alarm is being triggered when the residents
are cooking or showering
Solution: 1, clean the detector, refer to section 5 "Testing,
maintenance and cleaning "; 2, install the detector to another
place, refer to section 3 "lnstallation Location"
6
Publicidad
