Publicidad
Idiomas disponibles
Idiomas disponibles
READ ME FIRST
READ ME FIRST
Gas leak testing
Gas leak testing
It is important that you leak test the BBQ before first use and every time the gas cylinder is refilled and
It is important that you leak test the BBQ before first use and every time the gas cylinder is refilled and
reconnected to the BBQ.
reconnected to the BBQ.
To Complete Leak Test
To Complete Leak Test
• Make sure all the control knobs are OFF.
À LIRE EN PREMIER
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Mix the solution well (about the same concentrate as washing up water).
Test de fuite de gaz
• Turn the cylinder ON by rotating the knob to open position.
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
Il est important de tester l'étanchéité de l'appareil avant la première utilisation et à chaque fois que la bout-
- the gas connection at the inlet of the BBQ
- the gas connection at the inlet of the BBQ
eille de gaz est rechargée et reconnectée à l'appareil.
- all gas hose connections
- all gas hose connections
- the gas connection at the gas cylinder
- the gas connection at the gas cylinder
Pour terminer le test d'étanchéité
• If bubbles appear, there is a gas leak.
• If bubbles appear, there is a gas leak.
• Assurez-vous que tous les boutons de commande soient en position OFF.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is at the connection, re-tighten and re-seal.
• Dans un petit récipient, mélangez une solution d'eau et de détergent/savon.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Mélangez bien la solution (à peu près le même concentré que l'eau savonneuse).
• Replace gas hose and regulator.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
• Réglez le régulateur de la bouteille de gaz en position ouverte.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
• À l'aide d'une brosse ou d'un flacon pulvérisateur, appliquez la solution savonneuse sur la conduite de gaz
et sur chaque connexion dans la conduite de gaz, y compris :
- le raccord de gaz à l'entrée de l'appareil
- tous les raccords de tuyau de gaz
- la connexion de gaz au niveau de la bouteille de gaz
• Si des bulles apparaissent, c'est que vous êtes en présence d'une fuite de gaz.
• Si la fuite est au niveau de la connexion, resserrez et refermez hermétiquement.
• Si la fuite est ailleurs ou si vous ne pouvez pas résoudre la fuite en reserrant la connexion NE CONTINUEZ PAS.
• Remplacez le tuyau à gaz et le régulateur.
• Le tuyau de remplacement et les régulateurs peuvent être achetés auprès de votre spécialiste local de la
vente au détail de chaudières.
78
READ ME FIRST
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before first use and every time the gas cylinder is refilled and
Gas leak testing
reconnected to the BBQ.
It is important that you leak test the BBQ before first use and every time the gas cylinder is refilled and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
To Complete Leak Test
• In a small container, mix up a solution of water and detergent/soap.
• Make sure all the control knobs are OFF.
• Mix the solution well (about the same concentrate as washing up water).
• In a small container, mix up a solution of water and detergent/soap.
• Turn the cylinder ON by rotating the knob to open position.
• Mix the solution well (about the same concentrate as washing up water).
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
• Turn the cylinder ON by rotating the knob to open position.
- the gas connection at the inlet of the BBQ
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line includin
- all gas hose connections
- the gas connection at the inlet of the BBQ
- the gas connection at the gas cylinder
- all gas hose connections
• If bubbles appear, there is a gas leak.
- the gas connection at the gas cylinder
• If the leak is at the connection, re-tighten and re-seal.
• If bubbles appear, there is a gas leak.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCE
• If the leak is at the connection, re-tighten and re-seal.
• Replace gas hose and regulator.
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROC
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
Publicidad
